Critical Minerals

Sarytogan sends Kazakh battery graphite to Europe for pouch-cell tests ahead of DFS

US trials purified Karaganda graphite above 99.99% carbon; offtake samples are in Europe and the upstream feasibility study is due next quarter.

Written with AI tools by Corridor Minerals' editorial system; the publisher is responsible for it. How this site works

A flat lump of shiny dark grey graphite with rusty orange patches, on a black background
A specimen of pure graphite measuring 11 by 6.5 cm, 2015 Photo: Zbynek Burival, CC BY-SA 4.0, via Wikimedia Commons, cropped

Sarytogan Graphite, the ASX-listed developer of a graphite deposit in Kazakhstan's Karaganda region, will send 5 kilograms of coated spherical purified graphite (CSPG) to a battery prototyping organisation in Europe to be built into large-format lithium-ion pouch cells, after scaled-up processing trials in the United States, the company said on 14 September. Samples of its products are also with potential industrial offtake partners in Europe, and samples of the higher-value grades are being prepared for prospective battery customers to qualify.

The top of the first page of Downstream High-Quality CSPG
The first page of the document: Downstream High-Quality CSPG. Sarytogan Graphite (ASX announcement), 14 September 2026.

The step matters for the company's financing route. Its upstream definitive feasibility study, covering a flotation concentrate for industrial uses, is in its final stages and is due next quarter, and it will be followed by a separate downstream study and further environmental and social impact assessment "for international banks", the announcement says. The project is designated a Strategic Project under the European Union's Critical Raw Materials Act, according to the company.

What the trials produced

About 30 kilograms of ultra-high-purity fines and of uncoated and coated spherical purified graphite were produced from concentrate made from a 24-tonne trench sample taken in 2024 in the deposit's Central Graphite Zone, the company said. The sample was crushed and milled at KazHydromed in Kazakhstan, concentrated at Metallurgy Pty Ltd's laboratory in Perth and purified, spheroidised and coated by American Energy Technologies Company (AETC) in Illinois.

Purification in a continuous fluidised bed reactor at about 2,800 degrees Celsius, without acids or halogens, gave grades above 99.99 per cent carbon, against a typical battery specification of 99.95 per cent cited by AETC. After spheroidisation, the classified fractions had tap densities of 0.99 to 1.26 grams per cubic centimetre for cuts 0 to 7 and median particle sizes of 4 to 12 microns, compared with 0.9 to 1.02 grams and 12 to 32 microns in the company's 2023 and 2024 tests. The spheroidisation yield could reach 97.7 per cent if cuts 0 to 7 are all used; the industry typical range given in the announcement is 50 to 60 per cent. AETC said tap densities above 1.2 grams per cubic centimetre were very rare in the battery industry, according to the company.

Three of the finer cuts were coated with soft carbon to make the active anode material that will now be tested. Earlier coin-cell tests were run in 2024, and the pouch-cell tests at 5 ampere-hours are a scale-up from those, the release says. Electrochemical results have not yet been published.

Resource and reserve base

Sarytogan's mineral resource estimates total 225 million tonnes at 29.2 per cent total graphitic carbon, and its probable ore reserve, first reported in August 2024, is 8.587 million dry tonnes at 30.0 per cent, yielding 2.654 million dry tonnes of concentrate at 81.4 per cent, according to the tables in the announcement. The deposit lies 190 kilometres by highway from the city of Karaganda and is held through the wholly owned subsidiary Ushtogan LLP, which resumed exploration in 2018. The company plans three product groups: the 90 per cent "Micro90C" concentrate for lubricants, friction products, foundry and recarburiser uses; ultra-high-purity fines for alkaline and lithium primary batteries; and spherical graphite for lithium-ion battery anodes. Micro90C samples are already with potential foundry and recarburiser customers in Europe.

Copper on the side

The company is also exploring for copper. On 24 September it reported the third of three diamond holes at the Ilksan prospect of its Baynazar project, 25 kilometres south-west of the graphite deposit: 452 metres at 0.063 per cent copper from surface to the end of the hole, the announcement shows. Earlier holes returned 318 metres at 0.14 per cent copper, including 15.2 metres at 0.40 per cent, and 229 metres at 0.14 per cent. The company said the drilling confirmed porphyry-style mineralisation and that further drilling would target the south and west of the prospect.

Neither announcement gives a capital cost, an offtake price or a financing package for the graphite project; the company says those will follow from the feasibility studies.

Sources

Assay notes

  1. Downstream High-Quality CSPGSarytogan Graphite (ASX announcement), Primary source, 14 September 2026
  2. Copper Mineralisation Extended at IlksanSarytogan Graphite (ASX announcement), Primary source, 24 September 2026